记作业>英语词典>air pocket翻译和用法

air pocket

英 [ˈeə pɒkɪt]

美 [ˈer pɑːkɪt]

n.  气窝; 气阱,气穴(使飞机突然下降的低气压区)

化学

牛津词典

    noun

    • 气窝
      a closed area that becomes filled with air
      1. 气阱,气穴(使飞机突然下降的低气压区)
        an area of low air pressure that makes a plane suddenly drop while flying

        英英释义

        noun

        • a local region of low pressure or descending air that causes a plane to lose height suddenly
            Synonym:pocketair hole

          双语例句

          • All this is probably an air pocket;
            这一切或许是如“气囊”一般的保护性反应;
          • After safe air pocket and ABS, TPMS is a new generation produc of auto safe in international auto field. The Best Way to Alleviate Water Hammer of Cavities Collapsing and Pressure Rising Incurred by Air Pocket Motion
            TPMS是继安全气囊、ABS刹车系统之后,在国际汽车领域出现的新一代汽车安全配备用品。消减断流弥合水锤及气囊运动升压的最佳方式
          • Test research Formation Causes of Air Pocket Producing in Bucket Dissipation of Cha 'yuan Reservoir
            茶园水库挑流消能中气囊产生成因及试验研究
          • The leading car disturbs the air and does all of the work, the following car ( travelling in a nice pocket with almost no wind resistance) is not inhibited and can build up speed faster than normally possible.
            前车驱赶走了空气,后车在几乎没有空气阻力的空洞里行驶,从而可能获得比平常更快的速度。
          • We had a bumpy flight because of air pocket.
            我们的飞行甚为颠簸,因为遇到气穴。
          • As they rapidly churn their legs, they slap their splayed feet hard against the water, creating a tiny air pocket that keeps them from sinking, provided they maintain their speed.
            当它们迅速摆腿,它们把展开的脚用力蹬水,如果保持了速度,那么所产生的小气涡能让它们不沉入水里。
          • The application of air pocket transportation technique in port& waterway engineering, the prospects of its popularization, as well as the specifications and technical parameters of the air pocket are introduced.
            介绍气囊搬运技术在水运工程中的应用情况及推广前景,介绍气囊的规格和技术参数。
          • Analysis and prevention of poor reactions induced by use of air pocket prelum arteriol during operation
            术中使用气囊止血带不良反应的原因分析及防护
          • Optimum cast gate is chosen, with reject rate reduced to 3% and air pocket avoided.
            铸造毛坯易出现气孔(缩松),该工艺选择了最佳浇口位置,将不良品率降至3%左右;
          • Second, numerical simulation of filling, flow, air pocket, fusion trace, and warp were performed with simulation software Mold flow.
            其次,利用仿真软件Moldflow对该注塑件进行充填、流动、冷却、气穴、熔接痕、翘曲等数值模拟。